[confirm] No Signal after standby (1 Viewer)

[cecet23]

MediaPortal Version: Mediaportal 1.1.0 rc2
MediaPortal Skin: StreamedMp
Windows Version: Windows7 Ultimate
CPU Type: Amd x2 4450e 2.3
HDD: 1tb Hitachi
Memory: 2gb Kingstom 800mhz
Motherboard: Asrock K10N78FullHD-hSLI
Video Card: Nvidia Gt220
Video Card Driver: 196.xx
Sound Card: Creative Audigy se
Sound Card AC3:
Sound Card Driver:
1. TV Card: Skystar dvb-s2
1. TV Card Type: DVB-s2
1. TV Card Driver:
2. TV Card:
2. TV Card Type:
2. TV Card Driver:
3. TV Card:
3. TV Card Type:
3. TV Card Driver:
4. TV Card:
4. TV Card Type:
4. TV Card Driver:
MPEG2 Video Codec:
MPEG2 Audio Codec: Microsoft
h.264 Video Codec: Microsoft
Satelite/CableTV Provider: Hotbird 13.0E
HTPC Case: Chieftec hm-02b
Cooling:
Power Supply:
Remote: IMON
TV: LG Full-hd 32'
TV - HTPC Connection: HDMI

I upgraded to rc3 and now I have one problem. After standby if I try to open the same channel that i used before standby, I receive "no signal". I have to change transponder and the tv start again.
I attached my log..

 

[romuz]

Could you try reinitialise service option of power scheduler plugin?

 

[cecet23]

Could you try reinitialise service option of power scheduler plugin?

Whit this option it work...but for me that is a bug, it never happened with rc2 - rc1.

 

[robyf]

If it works with this option, where is the problem?

Are you sure you didn't change anything (for instance drivers, firmwares or other software components)?

For instance for me it worked with this option disabled, but after an update of floppydtv firmware I had to enable this option to make MP work after standby.

I also cannot reproduce this problem, so it must related to your particular hardware/software configuration.

 

[cecet23]

If it works with this option, where is the problem?

Are you sure you didn't change anything (for instance drivers, firmwares or other software components)?

For instance for me it worked with this option disabled, but after an update of floppydtv firmware I had to enable this option to make MP work after standby.

I also cannot reproduce this problem, so it must related to your particular hardware/software configuration.

I haven't a problem, but if that happen only with rc3 maybe something is wrong, and maybe you have to pay a bit attention (I think).


The only thing that i did was the upgrade from rc2 to rc3.. (I tried a new installation as well but without success)

 

[chrholm]

I have had problems with No signal after update to RC3. This started just after the upgrade, and I have never seen it before, so something must have changed with RC3. It seems to be stable for some time, and then suddenly it will start producing "No signal" all the time.

 

[riksmith]

This problem could also be related to the fix for:

0002880: Unable to tune same ATSC channel/subchannel consecutively - MediaPortal Bugtracker

 

[riksmith]

I have had problems with No signal after update to RC3. This started just after the upgrade, and I have never seen it before, so something must have changed with RC3. It seems to be stable for some time, and then suddenly it will start producing "No signal" all the time.

If it is not related to "standby" please start a new thread or find a matching one.