England
Hey everyone,
Wasnt sure where to post this, this seemed like the best place. I have an ATI graphics card with CCC installed. It is connected to my 47" LG 47LF66 1080p television on HDMI 1. I have a DVI to HDMI belkin cable which is sending the signal to the television.
My problem is, if i change my television from HDMI1 to HDMI2 (to play PS3 for example) and then back from HDMI2 to HDMI1, i get a 'No Signal' from my HTPC. Note that this is happens if i'm running Mediaportal or not running it.
More details...
If i restart the computer when it's in that state, the screen comes back and it boots fine.
When in the 'No Signal' state, if I put the HTPC into sleep, and then bring it out of sleep, the picture comes back.
To the best of my knowledge the refresh rate is always set to 60hz
Please help! This is very annoying
Wasnt sure where to post this, this seemed like the best place. I have an ATI graphics card with CCC installed. It is connected to my 47" LG 47LF66 1080p television on HDMI 1. I have a DVI to HDMI belkin cable which is sending the signal to the television.
My problem is, if i change my television from HDMI1 to HDMI2 (to play PS3 for example) and then back from HDMI2 to HDMI1, i get a 'No Signal' from my HTPC. Note that this is happens if i'm running Mediaportal or not running it.
More details...
If i restart the computer when it's in that state, the screen comes back and it boots fine.
When in the 'No Signal' state, if I put the HTPC into sleep, and then bring it out of sleep, the picture comes back.
To the best of my knowledge the refresh rate is always set to 60hz
Please help! This is very annoying