No signal (1 Viewer)

[magnush]

MediaPortal Version: 0.2.3.0
Windows Version: XP SP2
CPU Type: AMD Athlon
Memory: 1Gb
Motherboard: MSI
1. TV Card: Hauppauge PVR-150
1. TV Card Type: Analogue
1. TV Card Driver:


Hi.

I've just installed my PVR-150 card and have some problems.

When scanning for channels in Hauppauge WinTv it can't find any channels. When scanning for channels in Media Portal it finds a lot but when I try to watch I only get a black screeen and the message "No Signal".

What is the problem? All cables connected, although the cable from the antenna is a little long(5 meters).

 

[magnush]

Solved!

 

[shred]

you are sooo great not writing about the soluion!

how did you solve it? im having the same problem.

shred

 

[Clean]

I had a similar problem with my ATI 650. Turned out that my audio filter was buggered. I had turned off the necessary library in ffdshow. I went back and re-enabled it and everything was fine. 'Course, that did not happen until after I had blew away the set-up and re-installed everything. Why be easy?

 

[stimpy182]

It would be nice to know te solutions, because i have the same problem here.

 

[lowcrust]

I have the same problem (only I have 500MCE, which is the same card only with two tuners).

Never mind me, I'm a super newbie (I posted the above around 5 minutes after my MP install finished). It turned out I had the My TV plugin disabled (is this default?). Now it works like a charm. Good picture quality too.

I have a lot to learn still, this media center stuff (and MP specifically) seems very interesting!