Reply to thread

Message

<blockquote data-quote="patrick" data-source="post: 85389" data-attributes="member: 12502">Hi,Just jumping here, read through the thread but may have missed something.If ALL your channels are coming through the STB to MP via svideo there is no need/use in auto-tuning since the card is not actually tuning anychannels but just bringing in the svideo signal.Since you said coax and your channels go over 99 I am assuming you have a digital cable lineup, and you are using the zap2it plugin.Set the Zap2It plugin to automatically add your channels as external SVHS, it will add all your channels (with naming) and set them to svhs for you. So you may want to clear all your existing channels and try that.On a side note. If I understand your setup correctly I think you will only be able to watch/record one channel at a time even though you have two tuners on the PVR-500 because the STB is doing the tuning and passing that single channel to the card.My setup is similar except I have a PVR-150 in additiona to the PVR-500.I have coax run to all three for channels up to 99 and then havethe STB connected to the PVR-150 (via svideo) to record any channel 100+ via the STB.HTH,patrick</blockquote>

[QUOTE="patrick, post: 85389, member: 12502"] Hi, Just jumping here, read through the thread but may have missed something. If ALL your channels are coming through the STB to MP via svideo there is no need/use in auto-tuning since the card is not actually tuning any channels but just bringing in the svideo signal. Since you said coax and your channels go over 99 I am assuming you have a digital cable lineup, and you are using the zap2it plugin. Set the Zap2It plugin to automatically add your channels as external SVHS, it will add all your channels (with naming) and set them to svhs for you. So you may want to clear all your existing channels and try that. On a side note. If I understand your setup correctly I think you will only be able to watch/record one channel at a time even though you have two tuners on the PVR-500 because the STB is doing the tuning and passing that single channel to the card. My setup is similar except I have a PVR-150 in additiona to the PVR-500. I have coax run to all three for channels up to 99 and then have the STB connected to the PVR-150 (via svideo) to record any channel 100+ via the STB. HTH, patrick [/QUOTE]

Verification