Reply to thread

Message

<blockquote data-quote="benwillcox" data-source="post: 645722" data-attributes="member: 106275">Was wondering if there is any way to change the position of the OSD in mediportal, i.e. the one that appears at the bottom of the screen when you skip forward, backwards whilst playing a movie.I have a Panasonic AE4000 which has automatic aspect ratio detection. The problem is that when playing a 2.35:1 movie and the projector has automatically zoomed so that only the active picture area is visible on the screen, the OSD appears right at the bottom of the 16:9 frame (i.e. in the lower black area zoomed off screen), then the PJ thinks we're now displaying a 16:9 movie and zooms back out.Ideally we could adjust the OSD position so it's a bit higher and therefore always within the active picture area, or even at the top of the screen instead of the bottom would be better. Is there a way to change this, is it a skin specific issue (I am using StreamedMP at the moment)?Thanks,Ben</blockquote>

[QUOTE="benwillcox, post: 645722, member: 106275"] Was wondering if there is any way to change the position of the OSD in mediportal, i.e. the one that appears at the bottom of the screen when you skip forward, backwards whilst playing a movie. I have a Panasonic AE4000 which has automatic aspect ratio detection. The problem is that when playing a 2.35:1 movie and the projector has automatically zoomed so that only the active picture area is visible on the screen, the OSD appears right at the bottom of the 16:9 frame (i.e. in the lower black area zoomed off screen), then the PJ thinks we're now displaying a 16:9 movie and zooms back out. Ideally we could adjust the OSD position so it's a bit higher and therefore always within the active picture area, or even at the top of the screen instead of the bottom would be better. Is there a way to change this, is it a skin specific issue (I am using StreamedMP at the moment)? Thanks, Ben [/QUOTE]

Verification