Reply to thread

Message

<blockquote data-quote="swamprat96" data-source="post: 659660" data-attributes="member: 105223">MediaPortal Version: 1.1.0MediaPortal Skin: StandardWindows Version: XPCPU Type: Pentium d 2.8HDD: 1TB seagateMemory: 1gbMotherboard: Intel D945PVSVideo Card: Video Card Driver: Nvidia 6600LE GigayteSound Card: on boardSound Card AC3: on boardSound Card Driver: Realtek Audio1. TV Card: Hauppage T500Remote: Logitech Harmony 515TV: LGTV - HTPC Connection: DVi-componentI'm trying to make the decision how to control the power on this setup.Currently I have power scheduler running and I've told the remote to leave the HTPC on. PS then puts the HTPC into suspend mode after 5 minutes(I'll extend that when I finish testing)- good. BUT the Harmony remote remembers the last power state and presumes the unit is still on - so when using the Watch TV activity - the remote does not send a power command. I can manually fire it but thats not the ideal solutionIf I allow the remote to power off the HTPC - will the power scheduler resume for recording?The other scenario is that I leave the HTPC on and disable the power scheduler. But this will suck power and again is not ideal. Any suggestions welcome</blockquote>

[QUOTE="swamprat96, post: 659660, member: 105223"] [b]MediaPortal Version[/b]: 1.1.0 [b]MediaPortal Skin[/b]: Standard [b]Windows Version[/b]: XP [b]CPU Type[/b]: Pentium d 2.8 [b]HDD[/b]: 1TB seagate [b]Memory[/b]: 1gb [b]Motherboard[/b]: Intel D945PVS [b]Video Card[/b]: [b]Video Card Driver[/b]: Nvidia 6600LE Gigayte [b]Sound Card[/b]: on board [b]Sound Card AC3[/b]: on board [b]Sound Card Driver[/b]: Realtek Audio [b]1. TV Card[/b]: Hauppage T500 [b]Remote[/b]: Logitech Harmony 515 [b]TV[/b]: LG [b]TV - HTPC Connection[/b]: DVi-component I'm trying to make the decision how to control the power on this setup. Currently I have power scheduler running and I've told the remote to leave the HTPC on. PS then puts the HTPC into suspend mode after 5 minutes(I'll extend that when I finish testing)- good. BUT the Harmony remote remembers the last power state and presumes the unit is still on - so when using the Watch TV activity - the remote does not send a power command. I can manually fire it but thats not the ideal solution If I allow the remote to power off the HTPC - will the power scheduler resume for recording? The other scenario is that I leave the HTPC on and disable the power scheduler. But this will suck power and again is not ideal. Any suggestions welcome [/QUOTE]

Verification