Reply to thread

Message

<blockquote data-quote="Taipan" data-source="post: 13172" data-attributes="member: 11681">[USER=10535]STSC[/USER]I am using exclusively Standby mode, but each time the PC wakes from Standby I have a script run that kills MP, restarts the DVB-T card's BDA drivers&nbsp; and then restarts MP in order to have anything recorded.I specified one minute as the startup and shutdown gap as this is the minimum that can be set in either MP or PVRS.However, I am still unable to get PVRS to put my PC into Standby when I have setup the recording schedule in MP and MP is at the Home Screen.&nbsp; Can you offer me any advice on this issue?&nbsp;&nbsp; :? [USER=10423]eagle[/USER]I assumed that the &quot;Auto Standby&quot; setting only referred to the situation where there are 2 or more scheduled recordings, and this was to avoid the PC being set to Standby, only to be woken again in a few minutes for the next recording?Does it also apply if there is just 1 scheduled recording?I have this parameter set to the default 20 minutes, so it could explain why my PC would not put itself to Standby, as all the tests I did were within 20 minutes of creating the schedule.Taipan</blockquote>

[QUOTE="Taipan, post: 13172, member: 11681"] [USER=10535]STSC[/USER] I am using exclusively Standby mode, but each time the PC wakes from Standby I have a script run that kills MP, restarts the DVB-T card's BDA drivers and then restarts MP in order to have anything recorded. I specified one minute as the startup and shutdown gap as this is the minimum that can be set in either MP or PVRS. However, I am still unable to get PVRS to put my PC into Standby when I have setup the recording schedule in MP and MP is at the Home Screen. Can you offer me any advice on this issue? :? [USER=10423]eagle[/USER] I assumed that the "Auto Standby" setting only referred to the situation where there are 2 or more scheduled recordings, and this was to avoid the PC being set to Standby, only to be woken again in a few minutes for the next recording? Does it also apply if there is just 1 scheduled recording? I have this parameter set to the default 20 minutes, so it could explain why my PC would not put itself to Standby, as all the tests I did were within 20 minutes of creating the schedule. Taipan [/QUOTE]

Verification