Reply to thread

Message

<blockquote data-quote="markrb" data-source="post: 556532" data-attributes="member: 19996">Re: SAF v4.00beta (StandAlone Filters) - DXVA ready (MPEG2, H.264 and VC-1).I have a Xonar Slim and successfully tested Dolby True-HD audio pass through and AC3 pass through without loosing any other audio features with SAF400Beta23test2.&nbsp; I have yet to test DTS-MA, but plan to soon.The Key with the Xonar is to register and use the Arcsoft Total Media 3 (don't know if 2 will work) audio renderer instead of default.&nbsp;&nbsp; The Xonar came with TMT3 or you can download a free copy from Asus that will only work if you have a Xonar installed.&nbsp; To register run the command regsvr32 ASAudioRenderer.dll in the C:\Program Files\ArcSoft\TotalMedia Theatre 3\Codec directory.&nbsp; After doing that the Arcsoft renderer will show up in MP.&nbsp;&nbsp; You still need to manually check off all the HD formats in ffdshow and setup ffdshow post processing in MP.&nbsp; I am not sure if it was needed, but I checked compatibility mode in ffdshow.I have only been running this way for a few hours and I do not use the TV server.&nbsp; I did have some issues, but I think I worked out the kinks at least I hope I did.I am finally getting a HTPC very close to perfect for me and it only has taken 2 years so far.Mark</blockquote>

[QUOTE="markrb, post: 556532, member: 19996"] [b]Re: SAF v4.00beta (StandAlone Filters) - DXVA ready (MPEG2, H.264 and VC-1).[/b] I have a Xonar Slim and successfully tested Dolby True-HD audio pass through and AC3 pass through without loosing any other audio features with SAF400Beta23test2. I have yet to test DTS-MA, but plan to soon. The Key with the Xonar is to register and use the Arcsoft Total Media 3 (don't know if 2 will work) audio renderer instead of default. The Xonar came with TMT3 or you can download a free copy from Asus that will only work if you have a Xonar installed. To register run the command regsvr32 ASAudioRenderer.dll in the C:\Program Files\ArcSoft\TotalMedia Theatre 3\Codec directory. After doing that the Arcsoft renderer will show up in MP. You still need to manually check off all the HD formats in ffdshow and setup ffdshow post processing in MP. I am not sure if it was needed, but I checked compatibility mode in ffdshow. I have only been running this way for a few hours and I do not use the TV server. I did have some issues, but I think I worked out the kinks at least I hope I did. I am finally getting a HTPC very close to perfect for me and it only has taken 2 years so far. Mark [/QUOTE]

Verification