Reply to thread

Message

<blockquote data-quote="edterbak" data-source="post: 602813" data-attributes="member: 69192">Re: AW: SAF v4.00 ''stable'' (StandAlone Filters) - DXVA ready (H.264 and VC-1).I have no information or experience with home server. But I doubt this is the cause of the problem. Good to know anyways.Should be ok here too.Default directsound should be ok. This is in MePo itself. In windows; Have you configured in windows configuration &gt; sound. the correct speaker setup?&nbsp; And do you find any settings in the realtec audio setup/config which says &quot;swap/switch channels x x x&quot;?You could try T-Spark's suggestion . If it doesnt work you can switch back again. See ffdshow audio &gt; codec tab.Just to be sure, have you ticked the [mixer] box in ffdshow? If it is unticked, the settings arent activated.And in the 'output' tab, passthrough dts and ac3 are unticked right?In MePo config &gt; codecs .... &gt; have you set ffdshow as MPEG/AC3 decoder and AAC decoder? Have&nbsp; you tried others which are availeble?Did you notice a sub folder in that codecs ... section called AAC Audio decoder settings. Is that correct over there?To see if it is a MePo problem only, you could try to play your mediafile in MPC-HC. You can find this in START &gt; SAF 4.0 programm folder . If it runs ok there and have no sound issue, it is likely a mepo settings issue.again, goodluck <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite1" alt=":)" title="Smile&nbsp; &nbsp; :)" loading="lazy" data-shortname=":)" /></blockquote>

[QUOTE="edterbak, post: 602813, member: 69192"] [b]Re: AW: SAF v4.00 ''stable'' (StandAlone Filters) - DXVA ready (H.264 and VC-1).[/b] I have no information or experience with home server. But I doubt this is the cause of the problem. Good to know anyways. Should be ok here too. Default directsound should be ok. This is in MePo itself. In windows; Have you configured in windows configuration > sound. the correct speaker setup? And do you find any settings in the realtec audio setup/config which says "swap/switch channels x x x"? You could try T-Spark's suggestion . If it doesnt work you can switch back again. See ffdshow audio > codec tab. Just to be sure, have you ticked the [mixer] box in ffdshow? If it is unticked, the settings arent activated. And in the 'output' tab, passthrough dts and ac3 are unticked right? In MePo config > codecs .... > have you set ffdshow as MPEG/AC3 decoder and AAC decoder? Have you tried others which are availeble? Did you notice a sub folder in that codecs ... section called AAC Audio decoder settings. Is that correct over there? To see if it is a MePo problem only, you could try to play your mediafile in MPC-HC. You can find this in START > SAF 4.0 programm folder . If it runs ok there and have no sound issue, it is likely a mepo settings issue. again, goodluck :) [/QUOTE]

Verification