Reply to thread

Message

<blockquote data-quote="gperkinson" data-source="post: 399612" data-attributes="member: 83961">Hi,What version of catalyst control center are you on? I do not see a TV sharening option?GrahamHi,Found out that the CoreAVC configuration did not update properly for &quot;Hardware De-Interlacing - I clicked OK instead of Apply. Still have motion blur however on TV3 and C4, so keen to get this sorted - I'm wondering whether there are any other tweaks?GrahamHi,Any thoughts now that you have my card details?I searched for driver updates and noticed on the ATI site there was an update released this month. This included catalyst control center and the driver. The latest catalyst control center version is 9.3 and looking at the one I have now, it mentions 2007.10 etc etc. Always a bit nervous doing version updates like this incase it screws up everything. Any thoughts on the above?RegardsGrahamHi Again,Another issue I noticed with the underscan at almost 0 - I seem to have my picture slightly cutoff at the top and bottom. Might be my version of catalyst control center? I have a comment about this added on this forum.Any thoughts appreciated.Graham</blockquote>

[QUOTE="gperkinson, post: 399612, member: 83961"] Hi, What version of catalyst control center are you on? I do not see a TV sharening option? Graham Hi, Found out that the CoreAVC configuration did not update properly for "Hardware De-Interlacing - I clicked OK instead of Apply. Still have motion blur however on TV3 and C4, so keen to get this sorted - I'm wondering whether there are any other tweaks? Graham Hi, Any thoughts now that you have my card details? I searched for driver updates and noticed on the ATI site there was an update released this month. This included catalyst control center and the driver. The latest catalyst control center version is 9.3 and looking at the one I have now, it mentions 2007.10 etc etc. Always a bit nervous doing version updates like this incase it screws up everything. Any thoughts on the above? Regards Graham Hi Again, Another issue I noticed with the underscan at almost 0 - I seem to have my picture slightly cutoff at the top and bottom. Might be my version of catalyst control center? I have a comment about this added on this forum. Any thoughts appreciated. Graham [/QUOTE]

Verification