Reply to thread

Message

<blockquote data-quote="cafe.racer" data-source="post: 482296" data-attributes="member: 81174">Thought it would be best to start a new thread, rather than discuss in the &quot;Feature Requests&quot; thread.Pussywagon asked me how I send serial commands, so I thought it best to describe my setup - I have a Cambridge Audio 340R Receiver that I control with serial commands and IRSS.&nbsp; My setup might not be too relevant, because I don't actually use MP, but hopefully some of it is relevant.I have the MCE Vista Remote (the white one) that I use with the older MCE Transceiver as it has blasters.&nbsp; I also blast IR to the TV to turn it on and off.The Serial Protocol for my amp is in <a href="http://www.cambridgeaudio.com/assets/documents/AP227921Azur540RV3SerialControlProtocolV1.pdf" target="_blank">this document</a>.When I look at my Translator setup, the specific command I have to turn the amp on is shown below, then the button mapping screen and the macro screen are also shown.Notice that the button mapping screen you have to click &quot;Set&quot; down at the bottom to Set the command that is used.</blockquote>

[QUOTE="cafe.racer, post: 482296, member: 81174"] Thought it would be best to start a new thread, rather than discuss in the "Feature Requests" thread. Pussywagon asked me how I send serial commands, so I thought it best to describe my setup - I have a Cambridge Audio 340R Receiver that I control with serial commands and IRSS. My setup might not be too relevant, because I don't actually use MP, but hopefully some of it is relevant. I have the MCE Vista Remote (the white one) that I use with the older MCE Transceiver as it has blasters. I also blast IR to the TV to turn it on and off. The Serial Protocol for my amp is in [URL="http://www.cambridgeaudio.com/assets/documents/AP227921Azur540RV3SerialControlProtocolV1.pdf"]this document[/URL]. When I look at my Translator setup, the specific command I have to turn the amp on is shown below, then the button mapping screen and the macro screen are also shown. Notice that the button mapping screen you have to click "Set" down at the bottom to Set the command that is used. [/QUOTE]

Verification