Reply to thread

Message

<blockquote data-quote="Requient" data-source="post: 189442" data-attributes="member: 48373">I recently decided to upgrade to the latest version of MP 0.2.3.0 and I faced a problem - My TV would not load at all. When I selected My TV on the main menu, I was brought to the MyTV screen and a blank error entitled 'My TV' were shown. I fired up MediaPortal configuration and when I went to the 'Televisions' tab, an error saying something like 'no graph can be set' or close to that appeared. I even tried deleting my previously configured capture cards and re-adding them again. However, each time I tried to add a new card, the same error came out.The second problem is a persistent one which I had since 0.2.2.0. No matter how I configure both Daemon Tools and MediaPortal to use the same drive and no to auto-run on its on, I can never get Daemon Tools to mount the image and play an ISO file inside Media Portal properly. Everytime I select an ISO in MP, a new window pops out saying it is loading and it stays there for a few seconds (progress bar does not move). After that few seconds, the window disappears and it is back to the previous screen (ie: it seems like nothing has been done).Can someone help me?</blockquote>

[QUOTE="Requient, post: 189442, member: 48373"] I recently decided to upgrade to the latest version of MP 0.2.3.0 and I faced a problem - My TV would not load at all. When I selected My TV on the main menu, I was brought to the MyTV screen and a blank error entitled 'My TV' were shown. I fired up MediaPortal configuration and when I went to the 'Televisions' tab, an error saying something like 'no graph can be set' or close to that appeared. I even tried deleting my previously configured capture cards and re-adding them again. However, each time I tried to add a new card, the same error came out. The second problem is a persistent one which I had since 0.2.2.0. No matter how I configure both Daemon Tools and MediaPortal to use the same drive and no to auto-run on its on, I can never get Daemon Tools to mount the image and play an ISO file inside Media Portal properly. Everytime I select an ISO in MP, a new window pops out saying it is loading and it stays there for a few seconds (progress bar does not move). After that few seconds, the window disappears and it is back to the previous screen (ie: it seems like nothing has been done). Can someone help me? [/QUOTE]

Verification