Reply to thread

Message

<blockquote data-quote="PatM" data-source="post: 1064040" data-attributes="member: 91742">I works!I set one channel to 62.15 in TVserver then exported the entire list (Channels only). Opened up export.xml in notepad and replaced all 'Frequency=&quot;0&quot;' with 'Frequency=&quot;&lt;the freq shown for the channel i changed above&gt;&quot;'. It's not 62.15 in the export file, its something like 0000621500 I deleted all channels then imported the modified export.xml. Mapped the channels to the colossus and the Hauppauge 885 and tried it out with the 885 at a higher priority. I left out a couple channels on the 885 just so I could see if the colossus would tune to those as well.The 885 tuned in a few channels while the rest said no signal. The colossus had no troubles. I messed around for a couple of hours trying to see why some channels worked on the 885 and others didn't. Finally I gave up temporarily and got the EPG going. While I was messing around with that I discovered that the previously &quot; no signal&quot; channels on the 885 had suddenly started working. As far as I can tell, every channel on the 885 works perfectly.Before getting the channel list from SD I set the source to Tuner. Don't know why the colossus works with channels set to Tuner instead of component - maybe Tuner's index in the source list is the same as component on the Colossus?Anyway, now I've got to figure out how to modify the skin because there isn't one that is suitable for non-perfect vision. I do OK but the wife can't read the tiny fonts on the 42&quot; from across the bedroom. On the 96&quot; it's no problem of course.</blockquote>

[QUOTE="PatM, post: 1064040, member: 91742"] I works! I set one channel to 62.15 in TVserver then exported the entire list (Channels only). Opened up export.xml in notepad and replaced all 'Frequency="0"' with 'Frequency="<the freq shown for the channel i changed above>"'. It's not 62.15 in the export file, its something like 0000621500 I deleted all channels then imported the modified export.xml. Mapped the channels to the colossus and the Hauppauge 885 and tried it out with the 885 at a higher priority. I left out a couple channels on the 885 just so I could see if the colossus would tune to those as well. The 885 tuned in a few channels while the rest said no signal. The colossus had no troubles. I messed around for a couple of hours trying to see why some channels worked on the 885 and others didn't. Finally I gave up temporarily and got the EPG going. While I was messing around with that I discovered that the previously " no signal" channels on the 885 had suddenly started working. As far as I can tell, every channel on the 885 works perfectly. Before getting the channel list from SD I set the source to Tuner. Don't know why the colossus works with channels set to Tuner instead of component - maybe Tuner's index in the source list is the same as component on the Colossus? Anyway, now I've got to figure out how to modify the skin because there isn't one that is suitable for non-perfect vision. I do OK but the wife can't read the tiny fonts on the 42" from across the bedroom. On the 96" it's no problem of course. [/QUOTE]

Verification