home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
General Forums
OffTopic
Suspend mode S3
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Paranoid Delusion" data-source="post: 127577" data-attributes="member: 13176"><p>Lets seperate your remote from the problem.</p><p></p><p>Can you connect a mouse, and enable it in device manager to "bring windows out of standby"</p><p></p><p>then put windows into sleep state from start menu, should see "entering standby" screen.</p><p></p><p>wait until no noise and then allow 30 seconds.</p><p></p><p>Move mouse and see if it comes out of standby.</p><p></p><p>Should resume back to windows, If not and it reboots then hopefully we have ok'd the remote as fault still exists, if it resumes from standby normally then something to do with remote.</p><p></p><p>What memory are you using, and voltage does it recommend by the manufacturer</p><p>if above fails. or try removing 1 memory module at a time if more than 1 fitted.</p><p></p><p>Make sure your bios is set to use optimised settings + S3 and save.</p></blockquote><p></p>
[QUOTE="Paranoid Delusion, post: 127577, member: 13176"] Lets seperate your remote from the problem. Can you connect a mouse, and enable it in device manager to "bring windows out of standby" then put windows into sleep state from start menu, should see "entering standby" screen. wait until no noise and then allow 30 seconds. Move mouse and see if it comes out of standby. Should resume back to windows, If not and it reboots then hopefully we have ok'd the remote as fault still exists, if it resumes from standby normally then something to do with remote. What memory are you using, and voltage does it recommend by the manufacturer if above fails. or try removing 1 memory module at a time if more than 1 fitted. Make sure your bios is set to use optimised settings + S3 and save. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
General Forums
OffTopic
Suspend mode S3
Contact us
RSS
Top
Bottom
