swithcing issues (1 Viewer)

[canucks604]

i currently have 4 sats hooked up to an Emp Centauri 9x8 multiswitch. the way this switch work is that it has a 2 port diseqc & 22kz. so sat A is on port 1 22khz off, sat B is on port 1 22khz on and same thing for port 2 with sat c & d.

I can get all sats to scan with the following settings:

SAT #A: Diseqc Level1AA Band: Ku-Linear(Univ) Sat:
SAT #B: Diseqc Level1AA Band: Ku-Linear(Univ) Sat:

for A & B when i scan, i check the box that says "Override default LNB Freq" and enter
11250 for both LOF1 & LOF2
12700 for LNBSW

SAT #C: Diseqc Level1AB Band: Ku-Linear(Univ) Sat:
SAT #D: Diseqc Level1AB Band: Ku-Linear(Univ) Sat:
for C & D when i scan, i check the box that says "Override default LNB Freq" and enter
11250 for both LOF1 & LOF2
12200 for LNBSW

now here's the predicament

if i now uncheck the "Override default LNB Freq" box and goto preview a channel from any sat, it won't tune.
if i check the "Override default LNB Freq" and have the value of 12700 for LNBSW then it will tune to sat A & C
if i check the "Override default LNB Freq" and have the value of 12200 for LNBSW then it will tune to sat B & D

the question is, can i some how change the settings so that 12700 be applied for lnb#1 & 2 etc... through the database or would i need to hack it in the code ?

thanks

 

[kid]

hello
How to 6 LNBs multiswitch TVE3
I have a Hauppauge Nova-S Plus
Emp Centauri 9x8 multiswitch
MSI Medialive