Reply to thread

Message

<blockquote data-quote="Normann" data-source="post: 1251198" data-attributes="member: 163477">If the chosen channel is working there is a green led glowing as my tuner is locking on the right frequency. Sometimes when it is not working it glows and sometimes not. In ”preview” channel in ”TVServerConf” it seems to indicate ”no PMT” when the green led is glowing and ”no signal” when not glowing. This get me to think that trying to start a new channel on another LBN where there happens to be a frequency on the old LNB to lock on but this is the wrong provider it gives a green light but ”no PMT” and if there is no frequency to lock on, no light. So my speculation is that it locks before the proper changing of LNB has been made but happens to find a frequency on the old LNB to lock on.Now, I have increased scanning times in ”TVServerConf” &gt; ”General” &gt; ”Scan” without actually knowing what those settings are doing. I suppose they are only used for scanning new channels?If this thought holds I need a delay of – say – two sec between the command to set LNB to the locking of channel. So, we are stuck on figure out where we can put this delay and get it effectuated. I know nil of coding.</blockquote>

[QUOTE="Normann, post: 1251198, member: 163477"] If the chosen channel is working there is a green led glowing as my tuner is locking on the right frequency. Sometimes when it is not working it glows and sometimes not. In ”preview” channel in ”TVServerConf” it seems to indicate ”no PMT” when the green led is glowing and ”no signal” when not glowing. This get me to think that trying to start a new channel on another LBN where there happens to be a frequency on the old LNB to lock on but this is the wrong provider it gives a green light but ”no PMT” and if there is no frequency to lock on, no light. So my speculation is that it locks before the proper changing of LNB has been made but happens to find a frequency on the old LNB to lock on. Now, I have increased scanning times in ”TVServerConf” > ”General” > ”Scan” without actually knowing what those settings are doing. I suppose they are only used for scanning new channels? If this thought holds I need a delay of – say – two sec between the command to set LNB to the locking of channel. So, we are stuck on figure out where we can put this delay and get it effectuated. I know nil of coding. [/QUOTE]

Verification