Reply to thread

Message

<blockquote data-quote="Michael Walsh" data-source="post: 1132909" data-attributes="member: 143109">Hi There,I have exceedingly similar problems to ASPIK. Not only am I using the TT CT2-4400 Tuner, but it is also attached to the same Model of NUC PC ... Model D34010WYK.Although I can get everything to work, from time to time MediaPortal will simply stop finding the tuner and give approrpiate error messages. Whilsat I have been busy evaluating MediaPortal for the last couple of weeks (before placing it in my Living room), it has frequently hung when I have changed channels many times, ie: by just repeatedly hitting the CH+ key on the remote. Today we had been watching TV (worked fine!) then switched to watching a movie (MKV file) and when the movie was over, went back to TV mode where none of the TV channels were working. Even quickly rebooting the PC doesn't always help ... today it took two reboots before the card was available again! I've tried looking for a newer driver from TechnoTrend (which there isn't) and I have also increased the delay time to 10 seconds, as proposed earlier in this thread.If anyone has any further suggestions then they would be most welcome!Thanks - Michael.</blockquote>

[QUOTE="Michael Walsh, post: 1132909, member: 143109"] Hi There, I have exceedingly similar problems to ASPIK. Not only am I using the TT CT2-4400 Tuner, but it is also attached to the same Model of NUC PC ... Model D34010WYK. Although I can get everything to work, from time to time MediaPortal will simply stop finding the tuner and give approrpiate error messages. Whilsat I have been busy evaluating MediaPortal for the last couple of weeks (before placing it in my Living room), it has frequently hung when I have changed channels many times, ie: by just repeatedly hitting the CH+ key on the remote. Today we had been watching TV (worked fine!) then switched to watching a movie (MKV file) and when the movie was over, went back to TV mode where none of the TV channels were working. Even quickly rebooting the PC doesn't always help ... today it took two reboots before the card was available again! I've tried looking for a newer driver from TechnoTrend (which there isn't) and I have also increased the delay time to 10 seconds, as proposed earlier in this thread. If anyone has any further suggestions then they would be most welcome! Thanks - Michael. [/QUOTE]

Verification