Reply to thread

Message

<blockquote data-quote="Spragleknas" data-source="post: 221684" data-attributes="member: 17435">I am having a hard time quite understanding the issues here, but here goes:First: I am using STB (s-video) so I have no exp. with antenna/cable) (that is what you use, right.- Start with clean channel list etc. Remove everything in WebEPG-conf.exeNow: Since TV channels work fine in Win2000 - you can write down every channelname w/channel (or frequency) from thereIn setup (MediaPortal config):1. Add these manually in setup. Add name and channel. I remember this was what I had to do when I used antenna (used DScaler4 to find channels)2. Map channels to TV-cardOpen WebEPG-conf.exe (in MP directory)3. Hit: &quot;Import channel data&quot; - make sure source = MediaPortal4. Mark channel and map with correct EPG-sourcePlease tell me where things messes up. Note sure, but it MIGHT be taht the software from Hauppauge messes thing. Try not to use it after you read channels.I am not answering much here, but trying to find out where things get messed up.EDIT:Could you also attach configuration log?Found in : x:\xxx\Team MediaPortal\MediaPortal\LogAlso: This would be the preferred driver <a href="http://www.hauppauge.com/pages/support/support_mce.html" target="_blank">http://www.hauppauge.com/pages/support/support_mce.html</a></blockquote>

[QUOTE="Spragleknas, post: 221684, member: 17435"] I am having a hard time quite understanding the issues here, but here goes: First: I am using STB (s-video) so I have no exp. with antenna/cable) (that is what you use, right. - Start with clean channel list etc. Remove everything in WebEPG-conf.exe Now: Since TV channels work fine in Win2000 - you can write down every channelname w/channel (or frequency) from there In setup (MediaPortal config): 1. Add these manually in setup. Add name and channel. I remember this was what I had to do when I used antenna (used DScaler4 to find channels) 2. Map channels to TV-card Open WebEPG-conf.exe (in MP directory) 3. Hit: "Import channel data" - make sure source = MediaPortal 4. Mark channel and map with correct EPG-source Please tell me where things messes up. Note sure, but it MIGHT be taht the software from Hauppauge messes thing. Try not to use it after you read channels. I am not answering much here, but trying to find out where things get messed up. EDIT: Could you also attach configuration log? Found in : x:\xxx\Team MediaPortal\MediaPortal\Log Also: This would be the preferred driver [url]http://www.hauppauge.com/pages/support/support_mce.html[/url] [/QUOTE]

Verification