Area: Media Portal Program
MP Version: rc3
Skin: MCE
Windows Version: XP MCE 2005
CPU Type: P4 2.8
Memory: 512MB
Motherboard Chipset: Intel
Video Card: Radion 9550
Video Card Resolution: 1280x720
Video Codec Type & Version: Mpeg2Dec Filter
Audio Codec Type & Version: MPEG/AC3/DTS/LPCM Audio Decoder
TV Card: Hauppauge PVR500 mce (PAL)
Hi Guys
Been running MP for a couple of days now, and am trying to get up and running with ffdshow.
Have downloaded the recommended version from the MP site, and enabled post processing in the MP setup, and enabled OSD in ffdshow to see that its working, every thing else in ffdshow config is turned off.
The problem I have is that when post processing is active the picture is cropped on the right hand side, and I get a black bar on both left and right of the picture.
The OSD from ffdshow claims both input and output are 576x576, normally the TV Card outputs 576x720.
Bit new to all this stuff so any ideas where to start much appreciated
Cheers
MP Version: rc3
Skin: MCE
Windows Version: XP MCE 2005
CPU Type: P4 2.8
Memory: 512MB
Motherboard Chipset: Intel
Video Card: Radion 9550
Video Card Resolution: 1280x720
Video Codec Type & Version: Mpeg2Dec Filter
Audio Codec Type & Version: MPEG/AC3/DTS/LPCM Audio Decoder
TV Card: Hauppauge PVR500 mce (PAL)
Hi Guys
Been running MP for a couple of days now, and am trying to get up and running with ffdshow.
Have downloaded the recommended version from the MP site, and enabled post processing in the MP setup, and enabled OSD in ffdshow to see that its working, every thing else in ffdshow config is turned off.
The problem I have is that when post processing is active the picture is cropped on the right hand side, and I get a black bar on both left and right of the picture.
The OSD from ffdshow claims both input and output are 576x576, normally the TV Card outputs 576x720.
Bit new to all this stuff so any ideas where to start much appreciated
Cheers
Italy
