Reply to thread

Message

<blockquote data-quote="SciDoctor" data-source="post: 228261" data-attributes="member: 11346">The problem is the type of filter and graphedit not pre-asigning pin which is a very rare problem.The TVSERVER uses an inteligent graph build routine so doesn't have this problem.Now to help set up the standard MP.Open graphedit , select insert filter;Open BDA receiver or BDA source, highlight the twinhan filter which is probably a MANTIS DVBS.Look in the 'filter moniker' box for the number before '&amp;rev', for my instal it is '00281822'.In your MP directory there will be a file CaptureCardDefinitions about 1333k in size open this in NOTEPAD.Search for the instances of your number , mine was '00281822'.Check the devid is a match for the whole 'filter moniker', the part from pci to rev. If it doesn't then search for another match or edit .When you find an occurance read the filter construct and see if it is close match to your cards filters, check thoroughly as&nbsp; I found problem errors just with DVBT instead OF DVBS in the text.If there are NO match's then search for MANTIS and&nbsp; follow the above routine again.The important requirements are filter names and moniker numbers. Usualy teh pin connections are correct as the filters are simple single in/out on pin zero</blockquote>

[QUOTE="SciDoctor, post: 228261, member: 11346"] The problem is the type of filter and graphedit not pre-asigning pin which is a very rare problem. The TVSERVER uses an inteligent graph build routine so doesn't have this problem. Now to help set up the standard MP. Open graphedit , select insert filter; Open BDA receiver or BDA source, highlight the twinhan filter which is probably a MANTIS DVBS. Look in the 'filter moniker' box for the number before '&rev', for my instal it is '00281822'. In your MP directory there will be a file CaptureCardDefinitions about 1333k in size open this in NOTEPAD. Search for the instances of your number , mine was '00281822'. Check the devid is a match for the whole 'filter moniker', the part from pci to rev. If it doesn't then search for another match or edit . When you find an occurance read the filter construct and see if it is close match to your cards filters, check thoroughly as I found problem errors just with DVBT instead OF DVBS in the text. If there are NO match's then search for MANTIS and follow the above routine again. The important requirements are filter names and moniker numbers. Usualy teh pin connections are correct as the filters are simple single in/out on pin zero [/QUOTE]

Verification