Reply to thread

Message: <blockquote data-quote="Paul S" data-source="post: 94712" data-attributes="member: 20531">I'm not an expert, but you could start by building a graph using the filters that are listed for your card. When you connect the filters, you will then see the problem (hopefully). It looks like the the encoder settings use a "wildcard" entry. You could try to change this to the encoders that you have installed. Save a copy of the CaptureCardDefinitions file before you start to change it. You can go back to it if needed. Remember, your encoders may use different pin numbers, and they start with zero (top to bottom in a graph).The filter names would come from the GraphEdit entry. If your not sure how to do this, read the instructions for adding a new card in the wiki.Paul</blockquote>