Reply to thread

Message

<blockquote data-quote="sanja" data-source="post: 665397" data-attributes="member: 107520">I have an MCE remote connected to HTPC running Windows 7 Ultimate. The goal is to use single remote to operate the HTPC, the TV and the amplifier.I've tried IR server and LM remote keymap, both demonstrate the same behaviour. I open the debug program and point the remotes at the receiver; the LED inside receiver flashes as I press buttons and debug window shows that the commands are actually transmitted and received.Then I try to &quot;learn&quot; the programs. The problem is that when I enter the &quot;learn&quot; mode and press buttons on any remote (TV, home theater, radio) the LED inside the receiver doesn't blink at all. I keep trying for about 30 seconds, then the &quot;learning mode&quot; times out. Immediately after the receiver becomes responsive again.This is not a hardware problem - when I installed IR server for the very first time I was able to &quot;learn&quot; it to recognize two buttons from my TV remote and blast them back. Then I've rebooted the PC and since then have had no luck. No reinstalls and reboots did help.upd: browsing through the archives gave me this: <a href="https://forum.team-mediaportal.com/ir-server-suite-irss-165/learn-ir-does-not-work-77699/" target="_blank">https://forum.team-mediaportal.com/ir-server-suite-irss-165/learn-ir-does-not-work-77699/</a> It looks like I'll have to record IR files on XP machine and then transfer the setup to Windows 7 box..</blockquote>

[QUOTE="sanja, post: 665397, member: 107520"] I have an MCE remote connected to HTPC running Windows 7 Ultimate. The goal is to use single remote to operate the HTPC, the TV and the amplifier. I've tried IR server and LM remote keymap, both demonstrate the same behaviour. I open the debug program and point the remotes at the receiver; the LED inside receiver flashes as I press buttons and debug window shows that the commands are actually transmitted and received. Then I try to "learn" the programs. [B]The problem is that when I enter the "learn" mode and press buttons on any remote (TV, home theater, radio) the LED inside the receiver doesn't blink at all. I keep trying for about 30 seconds, then the "learning mode" times out. Immediately after the receiver becomes responsive again.[/B] This is not a hardware problem - when I installed IR server for the very first time I was able to "learn" it to recognize two buttons from my TV remote and blast them back. Then I've rebooted the PC and since then have had no luck. No reinstalls and reboots did help. upd: browsing through the archives gave me this: [url]https://forum.team-mediaportal.com/ir-server-suite-irss-165/learn-ir-does-not-work-77699/[/url] It looks like I'll have to record IR files on XP machine and then transfer the setup to Windows 7 box.. [/QUOTE]

Verification