Reply to thread

Message

<blockquote data-quote="exponent2" data-source="post: 230544" data-attributes="member: 64510">I'm not quite sure how translator is setup. I went to the programs tab and clicked on NEW. It prompted to press a remote button and I did. The red LED blinked indicating that the UIRT was receiving but nothing appeared in the code window. Should the code have been displayed?The application I use to test the UIRT is called IRHELPER. It works always regardless of whether translator, MP config or MP is running. The driver is the latest driver from USBUIRT. I tried disabling the UIRT in IR Service Config but this made no difference. The strange part is that in the remote configuration in MP config codes are read for Learn MP Command and teh LED works but the Learn Set Top BOX commands fails and the LED never works.I even did a new install of MP and IR suite with no change.Your help is appreciated.Thanks from VancouverProblem solved. I picked up the solution from another forum. For some odd reason when in &quot;learn&quot; mode you have to put the remote about an inch away from the receiver and old it at about a 45 degree angle. I did this and it worked flawlessly both receiving and sending.<img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite8" alt=":D" title="Big Grin&nbsp; &nbsp; :D" loading="lazy" data-shortname=":D" /></blockquote>

[QUOTE="exponent2, post: 230544, member: 64510"] I'm not quite sure how translator is setup. I went to the programs tab and clicked on NEW. It prompted to press a remote button and I did. The red LED blinked indicating that the UIRT was receiving but nothing appeared in the code window. Should the code have been displayed? The application I use to test the UIRT is called IRHELPER. It works always regardless of whether translator, MP config or MP is running. The driver is the latest driver from USBUIRT. I tried disabling the UIRT in IR Service Config but this made no difference. The strange part is that in the remote configuration in MP config codes are read for Learn MP Command and teh LED works but the Learn Set Top BOX commands fails and the LED never works. I even did a new install of MP and IR suite with no change. Your help is appreciated. Thanks from Vancouver Problem solved. I picked up the solution from another forum. For some odd reason when in "learn" mode you have to put the remote about an inch away from the receiver and old it at about a 45 degree angle. I did this and it worked flawlessly both receiving and sending.:thx: [/QUOTE]

Verification