Reply to thread

Message: <blockquote data-quote="mckzoo" data-source="post: 160760" data-attributes="member: 29260">The problem as I see it is to do with the ability to swiftly scroll through the recording and then pick the right point to Start/End.The Slider is a good idea however it is quite course meaning as it steps fwd in approx 1 min intervals. Then using the Fwd/Bk keys is tedious as they only step in 1 sec intervals. Whats worse is the Bk key is fighting against the fwd direction of the video, so 1 sec steps become even less.My suggestions1/ Increase the step interval of the Fwd/Bk keys to 5 or 10 secs. What would be better would be , Hold down the keys to jump continuously in 5 or 10 sec intervals, and Click the key to jump in 1 sec intervals2/ Make the skip interval for the Fwd / Back keys customizable. eg so Fwd = 5 sec, Back = 10 sec steps3/ Provide some Keyboard keys to perform the above functions ie Page keys to jump in large increments, Arrow key in small. Holding down the Key to jump continuously, clicking to make single steps4/ If the issue with getting to the end of file is a problem, is there some way to stop the scrolling a few seconds before the EOF to prevent the lockup. Maybe this could also be a Customizable setting.5/ Customizable settings accessible from the Pluin configuration screen in MP Setup.6/ Change the navigation required to get to  the Slider. I have to scroll through the on screen buttons to get to it before being able to use it. Then if you use the Fwd/Bk buttons you have to navigate back to the slider to enable it before you're able to use it. It would be much easier if the slider is enable or driven by the FFwd / FBk keys for example without having to first select it - or is this just the way I'm using it ?I'd be happy to be able to edit the recording to within 5 sec, 1 sec is a very small step. This is a small loss in the recording to gain significantly in speed of editing.Hope this helpsmckzoo</blockquote>

Verification