Hi all,
Hope I'm putting this post in the appropriate area?
Anyway, I've a new install on a W7 64bit
Hauppauge HVR-2250
When I am setting up the analog channels in server setup and it gets to the 17th scan I get a crash dump. Q scans fine no crash.
Side note, have (ewwww) WMC and it uses the Hauppauge fine (just hate WMC).
Read online re a driver change but that would be going to an older driver than the current one from Hauppauge.
Is there something I'm missing? Or perhaps there's a setting I missed reading about? I spent a lot of time preparing for this install and am pretty frustrated.
Any help will be most appreciated.
TIA, behoof
Hope I'm putting this post in the appropriate area?
Anyway, I've a new install on a W7 64bit
Hauppauge HVR-2250
When I am setting up the analog channels in server setup and it gets to the 17th scan I get a crash dump. Q scans fine no crash.
Side note, have (ewwww) WMC and it uses the Hauppauge fine (just hate WMC).
Read online re a driver change but that would be going to an older driver than the current one from Hauppauge.
Is there something I'm missing? Or perhaps there's a setting I missed reading about? I spent a lot of time preparing for this install and am pretty frustrated.
Any help will be most appreciated.
TIA, behoof