Reply to thread

Message

<blockquote data-quote="CyberSimian" data-source="post: 1165312" data-attributes="member: 141969">Interesting.&nbsp; To support long-press/typamatic action, the remote must wait for one of the following when a button is pressed:(1) The long-press/typamatic timeout to expire, or(2) The button to be released.If the remote sees (2), it can transmit the signal immediately (does not need to wait any more).&nbsp; I have just tested pressing and releasing as quickly as possible the UP and DOWN buttons in the EPG.&nbsp; I first used the Harmony 650, and then I used the One-for-All URC-7140.&nbsp; The Harmony is still perceptibly slower than the One-for-All. <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite3" alt=":(" title="Frown&nbsp; &nbsp; :(" loading="lazy" data-shortname=":(" />I vaguely remember seeing references in posts elsewhere to a 300 millisec &quot;interval&quot; in the Harmony software.&nbsp; I had assumed that this was the default gap between successive commands in a sequence (macro), but maybe it also applies to single commands (i.e. the time that passes before the command is sent).&nbsp; I think that this interval can be reduced to 100 millisec, so I will see if I can find the setting in the Harmony software and try a smaller value.-- from CyberSimian in the UK</blockquote>

[QUOTE="CyberSimian, post: 1165312, member: 141969"] Interesting. To support long-press/typamatic action, the remote must wait for one of the following when a button is pressed: (1) The long-press/typamatic timeout to expire, or (2) The button to be released. If the remote sees (2), it can transmit the signal immediately (does not need to wait any more). I have just tested [i]pressing and releasing as quickly as possible[/i] the UP and DOWN buttons in the EPG. I first used the Harmony 650, and then I used the One-for-All URC-7140. The Harmony is still perceptibly slower than the One-for-All. :( I vaguely remember seeing references in posts elsewhere to a 300 millisec "interval" in the Harmony software. I had assumed that this was the default gap between successive commands in a sequence (macro), but maybe it also applies to single commands (i.e. the time that passes before the command is sent). I [i]think[/i] that this interval can be reduced to 100 millisec, so I will see if I can find the setting in the Harmony software and try a smaller value. -- from CyberSimian in the UK [/QUOTE]

Verification