Reply to thread

Message: <blockquote data-quote="mm1352000" data-source="post: 748825" data-attributes="member: 82144">You weren't kidding about the logs length! <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite8" alt=":D" title="Big Grin    :D" loading="lazy" data-shortname=":D" />From what I can tell you've got Astra 28.2e on DiSEqC port BA and Astra 19.2e on port BB. You did at least 2 full scans this morning with lots of single scans.- Pretty much all the single scans were using the wrong frequency (eg. 12722 instead of 12721), so they didn't work (well one did, but that must have been a random chance).- The full scans mostly worked on vertical polarity, but horizontal polarity only worked up to 11954 MHz (ZDF).- DVB-S2 scanning worked on lower transponders, but it didn't work on higher transponders when other DVB-S transponders did work.- The transponders that do not work consistently do not work. The transponder that do work consistently work.You won't like this, but there is simply no explanation other than signal problems for the above conditions. If it were me, I would get a satellite installer in to check the dish and LNB alignment. It will cost some money, but at least you can be certain that things will be as good as possible at the dish.If your smartcard was able to be activated then it is likely I am wrong - ignore that comment. <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite10" alt=":oops:" title="Oops!    :oops:" loading="lazy" data-shortname=":oops:" />Best regards,mmPS: the frequency for TV Vlaanderen is 12722H - *way* above the working transponders. It would go so far as to say that it will not work in any software unless you fix the dish alignment. It might work if you remove the switches, but only because the signal level is increased when you don't have switches connected.</blockquote>

Verification