2 Problems with TV-Server in Single-Seat Configuration (1 Viewer)

[tom78]

TV-Server Version: Rev. 17615
MediaPortal Version: 0.2.3 Rev. 17615
MediaPortal Skin: MCE
Windows Version: XP Home SP2
CPU Type:
HDD:
Memory: 512MB
Motherboard: Via Epia EX 1500
Motherboard Chipset:
Motherboard Bios:
Video Card:
Video Card Driver:
Sound Card:
Sound Card AC3:
Sound Card Driver:
1. TV Card: Technotrend Budget S 1401
1. TV Card Type: DVB-S
1. TV Card Driver: 5.0.0.12
2. TV Card:
2. TV Card Type:
2. TV Card Driver:
3. TV Card:
3. TV Card Type:
3. TV Card Driver:
4. TV Card:
4. TV Card Type:
4. TV Card Driver:
MPEG2 Video Codec: Cyberlink
MPEG2 Audio Codec:
Satelite/CableTV Provider:
HTPC Case:
Cooling:
Power Supply:
Remote:
TV:
TV - HTPC Connection:


Hello everybody.

Yesterday i installed TV-Server and MP on my HTPC and i did some Tests.

First i want to say that it works nerly perfect! Great Work!!!
But when i close MP for Configuration or something else and after then i start it again, i can't get MyTV running.
Error Message: Could not start Graph.
What could be the reason for this?

The second point is, when changing TV-Channels, it takes about 3 seconds to see the new channel.
When changing Radio Channels, the time increases to about 30!!! seconds.
Has anyone an idea what could be the reason for this?

Thanks in advance

 

[james3005]

Similar problem

I had a similar problem when i first installed MP and i found that my tv card would stop being detected. When i checked in the device manager it was gone. It turned out that it was not seated in its slot properly when the bracket was screwed in (had to bend the bracked) Fixed problem1. Also check that you have mapped your channels in the tv server config and they are all checked with a tick. I also found that this error came up if you have a very poor signal or your antenna is disconnected.

I dont know if this helps but i hope it does

Cheers

 

[flokel]

The second point is, when changing TV-Channels, it takes about 3 seconds to see the new channel.
When changing Radio Channels, the time increases to about 30!!! seconds.
Has anyone an idea what could be the reason for this?

Thanks in advance

Could you post log files ?