home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
Installation, configuration support
Always no signal on my videomate s500 dtv tuner
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="gfmoore" data-source="post: 750131" data-attributes="member: 113222"><p>Okay, as I suspected when i got down this morning the scan was hung at the first line. I had to re-boot. The app would cancel (not the cancel scan), but the device seemed inaccessible.</p><p></p><p>Tried all your steps again with DVBS instead of Generic. 94 channels scanned, but no signal found on any of them.</p><p></p><p>I did check that no other drivers e.g. the media center processes were stopped (not that I use it on this machine) etc. I rechecked using DVBViewer - after the reboot and scan, that the device was accessible and it was fine. I've attached a jpg of the DVBViewer channel parameters page for the BBC West Midlands channel that I have been working with, just in case it helps.</p><p></p><p>I then scanned with DiSEQC set to levelAA, but same result.</p></blockquote><p></p>
[QUOTE="gfmoore, post: 750131, member: 113222"] Okay, as I suspected when i got down this morning the scan was hung at the first line. I had to re-boot. The app would cancel (not the cancel scan), but the device seemed inaccessible. Tried all your steps again with DVBS instead of Generic. 94 channels scanned, but no signal found on any of them. I did check that no other drivers e.g. the media center processes were stopped (not that I use it on this machine) etc. I rechecked using DVBViewer - after the reboot and scan, that the device was accessible and it was fine. I've attached a jpg of the DVBViewer channel parameters page for the BBC West Midlands channel that I have been working with, just in case it helps. I then scanned with DiSEQC set to levelAA, but same result. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
Installation, configuration support
Always no signal on my videomate s500 dtv tuner
Contact us
RSS
Top
Bottom
