Reply to thread

Message: <blockquote data-quote="TheBatfink" data-source="post: 1110059" data-attributes="member: 52265">Yes and it found the bridge. I'll redo the process again with debug on so the log is complete and post some screens of my settings.So I cleared the settings.xml of Atmohue and restarted my PC. I have left my Atmolight configured the way I had originally with respect to the Wiki. Here are the Generic Settings and Hue tabs screenshots:[ATTACH]157579[/ATTACH]   [ATTACH]157580[/ATTACH]I then:1) Loaded up Atmohue2) Enabled the debug log and remote api log check boxes3) Enabled the remote api checkbox (not sure if I need to do this)4) Enabled the auto connect if bridge found check box5) Clicked the locate and register hue bridge button6) Pressed the button on my Hue then clicked OK button on the Atmohue messagebox prompt as instructed7) Atmohue settings populate with IP address, app name and key etc.8) Clicked the LEDS tab and input my three lights and gave them ID 1, 2 and 3 (my setup currently contains 3 Hue bulbs, 1 bridge and 1 Hue Tap)9) Clicked the testing tab and clicked the colour test buttons one by one. Result: nothing happens and the lights remain in the off state10) Clicked the Experimental table and clicked the colour test buttons one by one. Result: nothing happens and the lights remain in the off state11) Clicked the Retrieve scenes and log button. Result: nothing appears to happenI then fired up the lights with the Hue App and closed the Hue App. I repeated steps 9 through 11. Result: Lights remain on the colours I set with the Hue App and do not change. Nothing appears to happen when clicking the retrieve scenes button.Here are my Atmohue settings screen shots and the debug log file / settings.xmk.[ATTACH]157582[/ATTACH]  [ATTACH]157583[/ATTACH]I then closed and re-opened Atmohue with the lights still in the on state. I see in the log: HUE has been initialized on startup. I repeat steps 9 through 11. Again I see no change in the colour of the lights but I do now see some new log entries in the app relating to scenes as per the below screen shot. I have many more scenes configured than this though?[ATTACH]157589[/ATTACH]I realise in the images that the config boxes are chopped off the bottom. The config screen is not resizable and when dialing into the machine with my laptop on remote desktop to take these images etc. my resolution can not display it all without hiding the taskbar. It would be nice if the form was resizable vertically and maybe anchor your log control so it resizes with the form <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite1" alt=":)" title="Smile    :)" loading="lazy" data-shortname=":)" /> Here is another screen shot with the taskbaer hidden where you can see the control on the bottom of the form is claiming it is Connected OK.[ATTACH]157591[/ATTACH]So basically it just doesn't seem to work (probably something I have configured wrong?). Any help would be much appreciated <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite1" alt=":)" title="Smile    :)" loading="lazy" data-shortname=":)" /> I hope this is all clear enough!EDIT: Added a second debug log after my last test..</blockquote>

Verification