Atmolight "delay on resume" seems don't work. (1 Viewer)

[azzuro]

Hello
@Lightning303

I have issue on resuming with Atmolight and Atmowin.

I use the Atmowakehelper tool for reconnect my Arduino on resume.

But i have always the notification "Atmowin Connection lost" when i resume.
change the delay on atmolight do nothing.

PS : i use MP 1.12Pre and the unofficial atmolight

i don't have log at this time.

 

[azzuro]

@Rick164 @popy

 

[Lightning303]

i don't have log at this time.

 

[azzuro]

I will send you the log. Cleaned.

 

[azzuro]

hello,
the logs. Atmowin ever work after resume.
i have reactivated the plugin today and device with atmowakehelper.

maybe i must set atmowakehelper in debug mode ...

 

[azzuro]

@Lightning303 : news ?

 

[Lightning303]

Yeah, looks like a logic mistake, i will have a look at it and give u a test version when ready.

 

[azzuro]

@Lightning303
i think the delay set inside Atmolight wait the entire main thread.
but i'm not sure really ...

 

[Lightning303]

The problem was that AtmoLight would start sending commands to the target even before the delay was over. So in your case AtmoWin was not ready yet and timed out. Should work now, please test and let me know.

 

[azzuro]

hello,
thank you for the patch, i have installed this one this morning. but testing very quickly before go to office.
what i can see, first impression :
- led show nothing : maybe due, this build is based on master.
- MP seems freeze during few minutes after GUI displayed. ( i have set 7 seconds to atmolight )

i use MP1.12 Pre, can you use the new framegrabber patch ?

i hope do more test in the evening.