Reply to thread

Message

<blockquote data-quote="Olli123" data-source="post: 1047003" data-attributes="member: 118653">Testvideo von meinem Ambilight:[media=youtube]uvuaNYkfYr8[/media]Are you using the AtmoWin out of this package?I also noticed that the behavior of LEDs is different to the version like &quot;AtmoWin_09_07_2013_Atmoduino+SEDU&quot; are others.....I can confirm this problem with the range but i think it has something to do with the settings and the whitebalancing / gamma correction.The settings from Angie05 should be used.The arduino is just sending the packages from AtmoWin to the stripes. Nothing more, nothing less. Normaly it works or not. But half-working should not be possible.Check your baudrate speed of the COM port to be 115200.Additionaly there is no need to use the FastSPI2 with the WS2801. They should be fine with the FastSPI1 also.FastSPI2 is only to use not supported stripes with atmoduino......</blockquote>

[QUOTE="Olli123, post: 1047003, member: 118653"] Testvideo von meinem Ambilight: [media=youtube]uvuaNYkfYr8[/media] Are you using the AtmoWin out of this package? I also noticed that the behavior of LEDs is different to the version like "AtmoWin_09_07_2013_Atmoduino+SEDU" are others..... I can confirm this problem with the range but i think it has something to do with the settings and the whitebalancing / gamma correction. The settings from Angie05 should be used. The arduino is just sending the packages from AtmoWin to the stripes. Nothing more, nothing less. Normaly it works or not. But half-working should not be possible. Check your baudrate speed of the COM port to be 115200. Additionaly there is no need to use the FastSPI2 with the WS2801. They should be fine with the FastSPI1 also. FastSPI2 is only to use not supported stripes with atmoduino...... [/QUOTE]

Verification