[WiP] Audio delay when using LAV Audio codec (1 Viewer)

Sebastiii

Development Group
  • Team MediaPortal
  • November 12, 2007
    16,583
    10,403
    France
    Home Country
    France France
    Description of Change

    This branch will permit to have enabled audio delay (based for FFDShow Engine) but this time for LAV Audio.
    This branch is based on 1.20 final.
    Set the value of the step (there will be -10 to 10 so 20 step) from MP GUI selection

    upload_2018-9-30_15-31-45.png


    upload_2018-9-30_15-33-54.png


    Jira Link : [MP1-4928] Add audio delay with LAVAudio - Jira
    Branch Link: MediaPortal/MediaPortal-1
    Review : MP1CR-862 MP1-4928 : Delay Audio with LAV - Under Review
    Wiki docs: To do.

    Steps to install and test
    Installation (latest version on the bottom on the below list)
     
    Last edited:

    daWooky

    MP Donator
  • Premium Supporter
  • April 3, 2012
    783
    871
    Home Country
    Germany Germany
    Bye bye last needed ffdshow function:LOL: tested it a bit and so far its working great.(y)(y)(y)
    there's only one thing i noticed, it would be nice if the delay would go back to zero ms or to the default/set value of the codec after playback. i don't remember if it was the same with ffd-show, but i think it would be handy.:p
     

    Sebastiii

    Development Group
  • Team MediaPortal
  • November 12, 2007
    16,583
    10,403
    France
    Home Country
    France France
    • Thread starter
    • Moderator
    • #4
    Hey :)

    It was my idea at first to reset it on start but i didn't do it, i didn't remember if this settings was kept for ffdshow, but it should be possible to do the trick :p
     

    Users who are viewing this thread

    Top Bottom