Reply to thread

Message

<blockquote data-quote="jameson_uk" data-source="post: 594093" data-attributes="member: 11220">I have my TV setup to output all audio via AC3Filter or FFDShow to encode stereo as Pro-Logic (which means the amp gets a DD 2.0 signal and flicks over to Pro-Logic mode but stays in stereo for music)In RC1 I am getting an odd issue where by the audio seems to be trying to change during channel change.&nbsp;&nbsp; When I tried using channel up/down buttons it seems to work smoothly and amp stays as is. If I change channel via number or via guide the amp notices a change in setting then goes back again into Pro-Logic.&nbsp;&nbsp; This did not used to happen in previous versions on MP and I have tried with both AC3Filter and FFDShow (I checked these were actually being used by checking out the remote graph in GraphStudio)This is happening on changes on same card so does not appear to be related to changing cards.Is there anything new in RC1 that would reset the graph on channel change?or any reason why I would have just started seeing this?</blockquote>

[QUOTE="jameson_uk, post: 594093, member: 11220"] I have my TV setup to output all audio via AC3Filter or FFDShow to encode stereo as Pro-Logic (which means the amp gets a DD 2.0 signal and flicks over to Pro-Logic mode but stays in stereo for music) In RC1 I am getting an odd issue where by the audio seems to be trying to change during channel change. When I tried using channel up/down buttons it seems to work smoothly and amp stays as is. If I change channel via number or via guide the amp notices a change in setting then goes back again into Pro-Logic. This did not used to happen in previous versions on MP and I have tried with both AC3Filter and FFDShow (I checked these were actually being used by checking out the remote graph in GraphStudio) This is happening on changes on same card so does not appear to be related to changing cards. Is there anything new in RC1 that would reset the graph on channel change?or any reason why I would have just started seeing this? [/QUOTE]

Verification