Reply to thread

Message

<blockquote data-quote="Blort" data-source="post: 856286" data-attributes="member: 122051">Hello,&nbsp;I'm running the latest version of MP as a single seat installation on a PC with no internet connection, but I'm having difficult configuring the TV server (with a DVB-S card) I can only pick up channels if I scan a specific transponder with all the right details... I've connected the PC to the net and updated all the satellites, although as I say it usually will be disconnected from the net.&nbsp;1) Even though all transponders have been updated, if I scan for channels on Hotbird 13.0E I get nothing, no signal strength etc. All transponders come up with &quot;No Signal&quot;. However, if I manually scan a specific Hotbird transponder with the following details:&nbsp;Frequency: 10719000 kHzSymbol Rate: 27500Polarisation: VerticalAll Other Settings: Not Set&nbsp;Then I get all channels on this transponder no problem, what could be happening here?&nbsp;2) Is there a way I can perform a blind scan on a satellite? It seems the MP doesn't like it unless there are a list of transponders to scan for a satellite, in which case is there a way I can view/edit the transponders for a specific satellite that MP uses when I select scan channels?&nbsp;Thanks.</blockquote>

[QUOTE="Blort, post: 856286, member: 122051"] Hello, I'm running the latest version of MP as a single seat installation on a PC with no internet connection, but I'm having difficult configuring the TV server (with a DVB-S card) I can only pick up channels if I scan a specific transponder with all the right details... I've connected the PC to the net and updated all the satellites, although as I say it usually will be disconnected from the net. 1) Even though all transponders have been updated, if I scan for channels on Hotbird 13.0E I get nothing, no signal strength etc. All transponders come up with "No Signal". However, if I manually scan a specific Hotbird transponder with the following details: Frequency: 10719000 kHz Symbol Rate: 27500 Polarisation: Vertical All Other Settings: Not Set Then I get all channels on this transponder no problem, what could be happening here? 2) Is there a way I can perform a blind scan on a satellite? It seems the MP doesn't like it unless there are a list of transponders to scan for a satellite, in which case is there a way I can view/edit the transponders for a specific satellite that MP uses when I select scan channels? Thanks. [/QUOTE]

Verification