cant get past "Failed to start local comms" (1 Viewer)

flynnd

MP Donator
  • Premium Supporter
  • October 30, 2009
    15
    0
    Home Country
    Ireland Ireland
    hi,

    ive been searching for a solution to this for a few days now but couldn't find anything helpful.

    im running MP 1.1 on vista 32 bit (fully updated)
    i installed IR Server Suite - Test Build 1.4.2.3158 and installed the tv server plugins
    i installed the tv3 blaster plugin and when i click on it to config, the header read tv3 blaster configuration but the page never changes.

    when i click again, i get the failed to start local comms notice.

    no matter what i disable/enable, i cannot find a cure

    any help or suggestions greatly appreciated


    p.s. i have a mce remote and and a general ir receiver that came with it. remote works perfectly in MP
    also, tv card is an haupauge pvr150
     

    flynnd

    MP Donator
  • Premium Supporter
  • October 30, 2009
    15
    0
    Home Country
    Ireland Ireland
    thanks chemelli,

    seems like the most easiest obvious answer :oops:

    every time i went to download post, i seemed to forget i had updated to 1.1 and so downloaded the older build.

    thanks for your quick response
     

    Users who are viewing this thread

    Top Bottom