Reply to thread

Message

<blockquote data-quote="Twanniej" data-source="post: 1130698" data-attributes="member: 151917">Hello,I'm new here and i'm going to build an ambilightlike setup.The stuff i got is:4m WS2812B Led stripRaspberry Pi B+HDMI SplitterHDMI2AVUSB Videograbber STK11605v 10a Power adapterOnly thing left i need to order is an arduino?But i was wondering when i connect my power adapter to my led strip don't i need to put a condensator between it?And which one do ineed? i'm not that good with electricity: <a href="http://www.kiwi-electronics.nl/prototyping/condensatoren/elektrolytische-condensatoren" target="_blank">http://www.kiwi-electronics.nl/prototyping/condensatoren/elektrolytische-condensatoren</a>Also the topic starter recommended a resistor between the data line from the arduino to the led strip, which type of resistor do i need? <a href="http://www.kiwi-electronics.nl/prototyping/weerstanden" target="_blank">http://www.kiwi-electronics.nl/prototyping/weerstanden</a>Most sites says 470 ohm but 1/4 watt or 1/2 watt?Hope you guys can help me out.Greetings</blockquote>

[QUOTE="Twanniej, post: 1130698, member: 151917"] Hello, I'm new here and i'm going to build an ambilightlike setup. The stuff i got is: 4m WS2812B Led strip Raspberry Pi B+ HDMI Splitter HDMI2AV USB Videograbber STK1160 5v 10a Power adapter Only thing left i need to order is an arduino? But i was wondering when i connect my power adapter to my led strip don't i need to put a condensator between it? And which one do ineed? i'm not that good with electricity: [URL]http://www.kiwi-electronics.nl/prototyping/condensatoren/elektrolytische-condensatoren[/URL] Also the topic starter recommended a resistor between the data line from the arduino to the led strip, which type of resistor do i need? [URL]http://www.kiwi-electronics.nl/prototyping/weerstanden[/URL] Most sites says 470 ohm but 1/4 watt or 1/2 watt? Hope you guys can help me out. Greetings [/QUOTE]

Verification