Reply to thread

Message

<blockquote data-quote="Hapo" data-source="post: 1150221" data-attributes="member: 154586">So, i followed your suggestion and i have installed openelec, after following this tutorial <a href="https://github.com/tvdzwan/hyperion/wiki/Installation-on-RPi-with-OpenELEC" target="_blank">https://github.com/tvdzwan/hyperion/wiki/Installation-on-RPi-with-OpenELEC</a> ive managed to do all the commands and installs with no problem (installing hyperion, configuring hypercom and changincg effects folder) but in the end when i do the TEST CODES such as:/storage/hyperion/bin/hyperion-remote.sh --priority 50 --color red --duration 5000None of my leds lights up, what can it be the problem? im going to upload some pictures of my mounted kit to check if you can see the problem, i know the photo is confusing so i wil try to explain what i have done with the cables.1. Ive connected the DI to MOSI (Yellow)2. Ive connected the CI to SCLK (Orange)3. Ive connected the 5+ to a 2-pin jumper (connected also to a DC Jack adapter) and the other side of the 2-pin jumper is connected to both 5V on Rpi (RED)4. Ive connected GND directly to Rpi and another GND from the DC jacl adapter also directly connected to another spot on RpiThats it, is there a problem in my connections? perhaps i need to cut new LED strips and solder it again? How can i test to see if the problem is not on the LED strip?thanks!!Ohh i forgot to say, i am using 5v 5A (As im using only 2.66meters of LED).</blockquote>

[QUOTE="Hapo, post: 1150221, member: 154586"] So, i followed your suggestion and i have installed openelec, after following this tutorial [URL]https://github.com/tvdzwan/hyperion/wiki/Installation-on-RPi-with-OpenELEC[/URL] ive managed to do all the commands and installs with no problem (installing hyperion, configuring hypercom and changincg effects folder) but in the end when i do the TEST CODES such as: /storage/hyperion/bin/hyperion-remote.sh --priority 50 --color red --duration 5000 None of my leds lights up, what can it be the problem? im going to upload some pictures of my mounted kit to check if you can see the problem, i know the photo is confusing so i wil try to explain what i have done with the cables. 1. Ive connected the DI to MOSI (Yellow) 2. Ive connected the CI to SCLK (Orange) 3. Ive connected the 5+ to a 2-pin jumper (connected also to a DC Jack adapter) and the other side of the 2-pin jumper is connected to both 5V on Rpi (RED) 4. Ive connected GND directly to Rpi and another GND from the DC jacl adapter also directly connected to another spot on Rpi Thats it, is there a problem in my connections? perhaps i need to cut new LED strips and solder it again? How can i test to see if the problem is not on the LED strip? thanks!! Ohh i forgot to say, i am using 5v 5A (As im using only 2.66meters of LED). [/QUOTE]

Verification