Reply to thread

Message

<blockquote data-quote="Rick164" data-source="post: 1150378" data-attributes="member: 17766">Ah right now I see <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite1" alt=":)" title="Smile&nbsp; &nbsp; :)" loading="lazy" data-shortname=":)" /> , should be fine this way but can always try connecting them like in the example so that they share the same 5v and GND cable on the rPi.Soldering points look good as well so wouldn't change that as its already hard to enough to do this right <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite2" alt=";)" title="Wink&nbsp; &nbsp; ;)" loading="lazy" data-shortname=";)" />In your Hyperion config do you have it setup like the below image (primarily the Type / Output / Baud rate) ?<img src="https://christianmoser.me/wp-content/uploads/2014/02/Screen-Shot-2014-05-13-at-16.34.04.png" alt="" class="fr-fic fr-dii fr-draggable " style="" /></blockquote>

[QUOTE="Rick164, post: 1150378, member: 17766"] Ah right now I see :) , should be fine this way but can always try connecting them like in the example so that they share the same 5v and GND cable on the rPi. Soldering points look good as well so wouldn't change that as its already hard to enough to do this right ;) In your Hyperion config do you have it setup like the below image (primarily the Type / Output / Baud rate) ? [IMG]https://christianmoser.me/wp-content/uploads/2014/02/Screen-Shot-2014-05-13-at-16.34.04.png[/IMG] [/QUOTE]

Verification