Double Tuner - only can record one at once (1 Viewer)

mrpacogp

New Member
May 1, 2013
4
0
51
Home Country
Spain Spain
Hello all people
I have a stv22 with the correctly drivers and setup on tv-server
I only can watch or record on channel at same time.
I have mapped all channels too.
I have to made separate folders for recording for each tuner?
 

mm1352000

Retired Team Member
  • Premium Supporter
  • September 1, 2008
    21,578
    8,228
    Home Country
    New Zealand New Zealand
    Hello mrpacogp

    2013-05-02 14:51:03.025744 [(19)]: Controller: channel #1 DVBT:tv:RTVE La 1 Freq:770000 ONID:8916 TSID:1016 SID:570 PMT:0x64 FTA:True LCN:10000 BandWidth:8
    2013-05-02 14:51:03.028744 [(19)]: Controller: card:2 type:DvbT can tune to channel
    2013-05-02 14:51:03.029744 [(19)]: Controller: card:2 type:DvbT users: 1
    2013-05-02 14:51:03.034744 [(19)]: Controller: card:3 type:DvbT channel not mapped
    2013-05-02 14:51:03.035744 [(19)]: Controller: card:1 type:DvbIP cannot tune to channel
    2013-05-02 14:51:03.035744 [(19)]: Controller: card:4 type:RadioWebStream cannot tune to channel
    2013-05-02 14:51:03.036744 [(19)]: Controller: found 1 card(s) for channel
    2013-05-02 14:51:03.036744 [(19)]: AdvancedCardAllocation.GetAvailableCardsForChannel took 15 msec
    2013-05-02 14:51:03.037744 [(19)]: Controller: card:2 type:DvbT is not available, tuned to different transponder
    2013-05-02 14:51:03.037744 [(19)]: Controller: found 0 free card(s)

    You need to link your channels to the second tuner so that TV Server knows that both tuners can be used to tune the channels.

    http://wiki.team-mediaportal.com/1_...Server_Configuration/03_TV_Channels/2_Mapping

    1. Open TV Server configuration.
    2. Expand the "TV Channels" section (click on the +) on the left.
    3. Select "TV Mapping".
    4. Select the first DVB-T tuner up the top.
    5. Select all the channels on the left - select top channel, press and hold shift, then press end.
    6. Click >>.
    7. Select the second DVB-T tuner up the top.
    8. Select all the channels on the left - select top channel, press and hold shift, then press end.
    9. Click >>.

    Done. :)
     

    mrpacogp

    New Member
    May 1, 2013
    4
    0
    51
    Home Country
    Spain Spain
    I have that done, all channels from the first colum on the left, to the second colum.
    My two tuners got all channels on colum named "Channels mapped to card"[DOUBLEPOST=1367502080][/DOUBLEPOST]Finally i have found my solution.
    I have removed all channels from card 3 from mapped to available. Later i have remapped to card 3 and works fine now.
    Thank you very much for your support.
     

    Users who are viewing this thread


    Write your reply...
    Top Bottom