Reply to thread

Message

<blockquote data-quote="corvy" data-source="post: 1126702" data-attributes="member: 28526">Hello all, I have been playing with this the last few days. First part I used some efforts to tune was the Mascom CAM. I have adjusted quite some settings in the expert menu by trial and error to get the most optimal decrypt performance and the settings are now as follows:&nbsp;CA systems: SINGLECA registration: STATICForce reading original PMT: OFFCA-PMT delete time: 1sCI-Watchdog: 1500 ms&nbsp;Not sure about these settings but at least now the decrypt is quite snappy and stable. Note, Mascom Conax v. 1.25.&nbsp;Then I have been playing more with the TV client. I have gone to using UNC paths for the timeshift and recordings and this gives a lot better performance. Still I have seen the black screen from time to time. Last change I did was to move MPEG2 and h.264 codec from LAV Video to Cyberlink PDVD 13. This last change has given quite good effect. With the codec change I am no longer able to provoke the black screen issue. Have now tuned some 200 channel changes without issues. Before I have only been able to do between 5-10 tunes before I get issues.&nbsp;Right now I am using the stock TSreader from 1.10, have also tried the latest development version in this thread without any issues. Current setup is stock, working very stable. I will give the new tsreader another run after a few days just to compare.&nbsp;Thanks.</blockquote>

[QUOTE="corvy, post: 1126702, member: 28526"] Hello all, I have been playing with this the last few days. First part I used some efforts to tune was the Mascom CAM. I have adjusted quite some settings in the expert menu by trial and error to get the most optimal decrypt performance and the settings are now as follows: CA systems: SINGLE CA registration: STATIC Force reading original PMT: OFF CA-PMT delete time: 1s CI-Watchdog: 1500 ms Not sure about these settings but at least now the decrypt is quite snappy and stable. Note, Mascom Conax v. 1.25. Then I have been playing more with the TV client. I have gone to using UNC paths for the timeshift and recordings and this gives a lot better performance. Still I have seen the black screen from time to time. Last change I did was to move MPEG2 and h.264 codec from LAV Video to Cyberlink PDVD 13. This last change has given quite good effect. With the codec change I am no longer able to provoke the black screen issue. Have now tuned some 200 channel changes without issues. Before I have only been able to do between 5-10 tunes before I get issues. Right now I am using the stock TSreader from 1.10, have also tried the latest development version in this thread without any issues. Current setup is stock, working very stable. I will give the new tsreader another run after a few days just to compare. Thanks. [/QUOTE]

Verification