Reply to thread

Message

<blockquote data-quote="not_null" data-source="post: 1091544" data-attributes="member: 148906">I appreciate these very fast responses!On the firewall part, I'm just running the built in firewall in Windows 8.1 and the default security on the Comcast modem/router. The modem shows:Allow (LAN-to-WAN): allBlocked: IDS enabled &amp; IDENT (port 113)In the Windows Firewall I have Media Center Extenders, MediaPortal, and MediaPortal Configuration listed twice all marked with full access but I'm not seeing anything that specifically says TV Server (edit: I did find &quot;SetupTv&quot; and give that full access too). I'm also running PIA VPN but I've disconnected that for now.As far as the server configuration, I've disabled the SchedulesDirect plugin and deleted all channels that it had added. I also changed the SDT/VCT timeout to 200 seconds and confirmed that CAM is enabled. After all that is is still saying &quot;out-of-band service information... signal locked, no channels found&quot; and returning 0/0 channels. One note, I am scanning on all 3 tuners at the same time, and I do have the HDHomeRun QuickTV up watching TV while it was scanning. I'm going to reboot and try it again without HDHomeRun QuickTV open. Fresh logs attached for good measure.</blockquote>

[QUOTE="not_null, post: 1091544, member: 148906"] I appreciate these very fast responses! On the firewall part, I'm just running the built in firewall in Windows 8.1 and the default security on the Comcast modem/router. The modem shows: Allow (LAN-to-WAN): all Blocked: IDS enabled & IDENT (port 113) In the Windows Firewall I have Media Center Extenders, MediaPortal, and MediaPortal Configuration listed twice all marked with full access but I'm not seeing anything that specifically says TV Server (edit: I did find "SetupTv" and give that full access too). I'm also running PIA VPN but I've disconnected that for now. As far as the server configuration, I've disabled the SchedulesDirect plugin and deleted all channels that it had added. I also changed the SDT/VCT timeout to 200 seconds and confirmed that CAM is enabled. After all that is is still saying "out-of-band service information... signal locked, no channels found" and returning 0/0 channels. One note, I am scanning on all 3 tuners at the same time, and I do have the HDHomeRun QuickTV up watching TV while it was scanning. I'm going to reboot and try it again without HDHomeRun QuickTV open. Fresh logs attached for good measure. [/QUOTE]

Verification