Getting a "Conax CA no access" error message (1 Viewer)

[zicoz]

I'm running the 1.3.0 alpha on my client and 1.2.3 on the server TV-server, and since it' seems to be a TV-server issue I'm posting the bugreport here.

As the topic sais I'm getting an error message that says "Conax CA no access" when I try to watch encrypted channels.

I'm using the Digital Devices Cine CT v6 card DVB-T with a Digital Devices CI-module

http://shop.digital-devices.de/Cine-CT-V6
http://shop.digital-devices.de/epages/62357162.sf/en_GB/?ObjectPath=/Shops/62357162/Products/092003

Anyone else getting this message? Attached are my logs

 

[mm1352000]

Hello zicoz

Sorry for the slow response.
There are no errors in the TV Server log.
Is the smartcard activated?

mm

 

[zicoz]

Hi, np, and thanks for the response.

I did a reinstall with the 1.3.0 alpha and it started working, but this morning I rebooted the server and now I'm getting the "unable to play: stream 3.0" error message, don't know if I should start a new thread in that part or the forum or just continue here.

 

[mm1352000]

The problem is with the communication between the client and server.

Failed to get a SDP description from URL rtsp://TV-Server:554/stream3.0 connect() failed: Unknown error

Check your networking and perhaps try using static IP addresses instead of hostnames.

 

[zicoz]

Thanks I'll do some testing with a smaller network later today.

 

[zicoz]

Ok, did a reboot of the entire network, and seems to be working now.