home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
Installation, configuration support
Guide: Perfect playback & Display calibration
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="kiwijunglist" data-source="post: 1006107" data-attributes="member: 76888"><p>You need to install TMT5 Trial and copy the dtsaudio decoder into the LAV directory, after that lav can properly decode dts-hd (??+/-true hd??) into a PCM stream for MPAR. AFAIK - PCM is lossless and can carry HD Audio, so it is essentially the same. It just gets decoded slightly earlier in the chain. You still need to use HDMI though. I assume that if sample rate + bit depth = auto then MPAR doesn't resample the HD Audio, but there is no system tray icon so you can't see what it is doing and I don't know if there is a way to tell what birate/sample rate is received by the AVR so you can double check the rates didn;t change.</p></blockquote><p></p>
[QUOTE="kiwijunglist, post: 1006107, member: 76888"] You need to install TMT5 Trial and copy the dtsaudio decoder into the LAV directory, after that lav can properly decode dts-hd (??+/-true hd??) into a PCM stream for MPAR. AFAIK - PCM is lossless and can carry HD Audio, so it is essentially the same. It just gets decoded slightly earlier in the chain. You still need to use HDMI though. I assume that if sample rate + bit depth = auto then MPAR doesn't resample the HD Audio, but there is no system tray icon so you can't see what it is doing and I don't know if there is a way to tell what birate/sample rate is received by the AVR so you can double check the rates didn;t change. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
Installation, configuration support
Guide: Perfect playback & Display calibration
Contact us
RSS
Top
Bottom