home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 1
Support
Installation, configuration support
Guide: Perfect playback & Display calibration
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="tachtevrenidis" data-source="post: 1015267" data-attributes="member: 142909"><p>Ok I think using DirectSound Device takes care of that BUT here is what does not seem right. When I use MPAR with the settings instructed in the guide and tune to a channel my received 'detects' dolby digital mode and switches (there is a light that comes on) and turns off when i stop TV. When I use directsound device, the receiver stays in pro logic mode the whole way. Also using MPAR, I can only control sound through my amp (makes sense since it just passes through the digital signal to my amp) while with DS device, I can do it via my MePo remote. The sound when using MPAR is noticeably better. Also I can't use different renderers for TV and Video as there is a HUGE different in volume levels and I also need to switch remote controls to control sound. </p><p> </p><p>Can somebody bring this together?</p></blockquote><p></p>
[QUOTE="tachtevrenidis, post: 1015267, member: 142909"] Ok I think using DirectSound Device takes care of that BUT here is what does not seem right. When I use MPAR with the settings instructed in the guide and tune to a channel my received 'detects' dolby digital mode and switches (there is a light that comes on) and turns off when i stop TV. When I use directsound device, the receiver stays in pro logic mode the whole way. Also using MPAR, I can only control sound through my amp (makes sense since it just passes through the digital signal to my amp) while with DS device, I can do it via my MePo remote. The sound when using MPAR is noticeably better. Also I can't use different renderers for TV and Video as there is a HUGE different in volume levels and I also need to switch remote controls to control sound. Can somebody bring this together? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 1
Support
Installation, configuration support
Guide: Perfect playback & Display calibration
Contact us
RSS
Top
Bottom
