I have a harmony 555 remote antec fusion pc with imon receiver. I am unable to configure the exit button on the remote go back or exit tried configuring both imon software mp and logitech software. My set-up has the logitec using antec fusion V2 profile. Which I belive is mce type copy imon is setup as as if it's a mce remote most things work, but the exit button does not work. I looked at logitech setup and it was not configured to a button, found a post some where which stated they set it to mce back button however I can not get this to respond. I assume if I set it to back and then set-up the configuration for media portal in the imon software to do ESC when the back button is pressed it would work but it does not
Does anyone have any ideas
Does anyone have any ideas