Reply to thread

Message

<blockquote data-quote="mrmojo666" data-source="post: 1269333" data-attributes="member: 18095">yessssss.....&nbsp; (unfortunately it is something not in the registry)I?m using this <a href="https://github.com/SuslikV/cfg-cam/releases" target="_blank">SuslikV/cfg-cam</a>this CLI can setupVideoProcAmp_BrightnessVideoProcAmp_ContrastVideoProcAmp_HueVideoProcAmp_SaturationVideoProcAmp_Sharpnessbut only on an active pvr session.ATM I'm workarounding by call each minute (forever) WebCameraConfig.exewhat&nbsp;&nbsp; I did is:WebCameraConfig.exe --savedevto get the config filethen I setup a task schedule to run webcamera config each minute, so when it is run without parameters it read the standard config file you have saved before (you can change values in the .cfg file, remember to save, at the first exe run it loads them)On my tv server running that exe each minutes is not creating any slowness or other side effect.PS: i think might be possible to write a server plugin that runs this exe after a channel start....</blockquote>

[QUOTE="mrmojo666, post: 1269333, member: 18095"] yessssss..... (unfortunately it is something not in the registry) I?m using this [URL='https://github.com/SuslikV/cfg-cam/releases']SuslikV/cfg-cam[/URL] this CLI can setup VideoProcAmp_Brightness VideoProcAmp_Contrast VideoProcAmp_Hue VideoProcAmp_Saturation VideoProcAmp_Sharpness but only on an active pvr session. ATM I'm workarounding by call each minute (forever) WebCameraConfig.exe what I did is: WebCameraConfig.exe --savedev to get the config file then I setup a task schedule to run webcamera config each minute, so when it is run without parameters it read the standard config file you have saved before (you can change values in the .cfg file, remember to save, at the first exe run it loads them) On my tv server running that exe each minutes is not creating any slowness or other side effect. PS: i think might be possible to write a server plugin that runs this exe after a channel start.... [/QUOTE]

Verification