home
products
contribute
download
documentation
forum
Home
Forums
New posts
Search forums
What's new
New posts
All posts
Latest activity
Members
Registered members
Current visitors
Donate
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Contact us
Close Menu
Forums
MediaPortal 2
General
Help-A-Noob! Scan for channels not working
Contact us
RSS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="GimpyGeek" data-source="post: 1154258" data-attributes="member: 155301"><p>Hello all. I just downloaded and installed MP2 to replace the no-longer-supported Windows Media Center. I have two K-World UB435-q USB adapters on my computer, connected to a HDTV antenna outside. Media Center worked fine, found all my channels and did accurate recordings.</p><p>When I run the MediaPortal TV Server Config and select one of the tuners and click on scan for channels, it very quickly goes through all the channels and says no signal found. I can tell the cards are not being used, as they have red lights on them when they are on, and the lights are off. </p><p>If I click on the "Test Channels" option of the TV Server Config, it shows that my cards are idle. How do I wake up the cards, so that they can be used?</p><p>I have attached my log files, if that helps.</p><p>Thanks!</p></blockquote><p></p>
[QUOTE="GimpyGeek, post: 1154258, member: 155301"] Hello all. I just downloaded and installed MP2 to replace the no-longer-supported Windows Media Center. I have two K-World UB435-q USB adapters on my computer, connected to a HDTV antenna outside. Media Center worked fine, found all my channels and did accurate recordings. When I run the MediaPortal TV Server Config and select one of the tuners and click on scan for channels, it very quickly goes through all the channels and says no signal found. I can tell the cards are not being used, as they have red lights on them when they are on, and the lights are off. If I click on the "Test Channels" option of the TV Server Config, it shows that my cards are idle. How do I wake up the cards, so that they can be used? I have attached my log files, if that helps. Thanks! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
MediaPortal 2
General
Help-A-Noob! Scan for channels not working
Contact us
RSS
Top
Bottom
