Reply to thread

Message

<blockquote data-quote="GregorV" data-source="post: 291943" data-attributes="member: 57522">Hi emerich,you may be right. At least there is a strong hints, that this behavior can be caused by two separate components. Some people also had this problem with TransEdit or ProgDVB and here mostly the LNB or cable change helped. If I remember correct then reports about this problem with some specific software (also MediaPortal) did also mention LNBs but often this did not really help. It worked with TransEdit, but not with the software they wanted to use.By the way - in the last days I found another interesting way to work around the problem.In my case I needed several restarts from TVServer service but more reliable/faster is the following:In TVSetup try to scan a high band channel - if it does not work (cannot build graph) then go to TVServers-&gt;Home and click the TV-card.Check 'override default LNB frequencies' and enter the necessary values&nbsp; for the sat/country e.g. for Astra/Germany 9750,10600,11701 (11701, because it is different than it was before - correct is 11700). 11700 - 11718 can be used without changing anything for Astra 19.2. Go back to TV-channels (takes some time due to internal reinitialization) and preview a high band channel - in most cases it will work immediately.After a new restart, if it does not work just change 11701 to 11702 (or back to 11700) and when you go back to TV-Channels it will work.In general: whenever a slight change is done in the card configuration the following reinit makes everything work. This points to a initialization issue for the Hauppauge cards.Gregor</blockquote>

[QUOTE="GregorV, post: 291943, member: 57522"] Hi emerich, you may be right. At least there is a strong hints, that this behavior can be caused by two separate components. Some people also had this problem with TransEdit or ProgDVB and here mostly the LNB or cable change helped. If I remember correct then reports about this problem with some specific software (also MediaPortal) did also mention LNBs but often this did not really help. It worked with TransEdit, but not with the software they wanted to use. By the way - in the last days I found another interesting way to work around the problem. In my case I needed several restarts from TVServer service but more reliable/faster is the following: In TVSetup try to scan a high band channel - if it does not work (cannot build graph) then go to TVServers->Home and click the TV-card. Check 'override default LNB frequencies' and enter the necessary values for the sat/country e.g. for Astra/Germany 9750,10600,11701 (11701, because it is different than it was before - correct is 11700). 11700 - 11718 can be used without changing anything for Astra 19.2. Go back to TV-channels (takes some time due to internal reinitialization) and preview a high band channel - in most cases it will work immediately. After a new restart, if it does not work just change 11701 to 11702 (or back to 11700) and when you go back to TV-Channels it will work. In general: whenever a slight change is done in the card configuration the following reinit makes everything work. This points to a initialization issue for the Hauppauge cards. Gregor [/QUOTE]

Verification