Reply to thread

Message

<blockquote data-quote="sbp" data-source="post: 75784" data-attributes="member: 23951">Hi, I'm using the Hauppauge blaster to control my sat box, and this is the steps that I used:1. You need to use the blasterconfig program that came with the TV-card. Here you must find the correct settings, so that you from this program can change the program on your sat-box. There are several different to choose from (on the drop down list). If your brand isn't there, then choose &quot;test all&quot; and probably it will find a match. You should be able to see that the blaster flashes, otherwise try to press the jack further into the TV-card (mine is rather difficult to push in).Edit/ It is very important that you place the blaster right on top of the IR_reciever on the sat box, because the blaster only has a very short range. A few mm off-place could be the difference between failure and sucess. So if you have problems in getting the sat box to react on the test program, then try to re-align the blaster/EditWhen you have this working, you can close the config program.2. Next you should enable the hauppauge blaster plugin in MP.3. Then you have to go into the TV-channel setup and here you define which channels that need to use the blaster and which number it should use. Se my post here: <a href="https://forum.team-mediaportal.com/showthread.php?t=9925" target="_blank">https://forum.team-mediaportal.com/showthread.php?t=9925</a>Hope this helpsSteen</blockquote>

[QUOTE="sbp, post: 75784, member: 23951"] Hi, I'm using the Hauppauge blaster to control my sat box, and this is the steps that I used: 1. You need to use the blasterconfig program that came with the TV-card. Here you must find the correct settings, so that you from this program can change the program on your sat-box. There are several different to choose from (on the drop down list). If your brand isn't there, then choose "test all" and probably it will find a match. You should be able to see that the blaster flashes, otherwise try to press the jack further into the TV-card (mine is rather difficult to push in). Edit/ It is very important that you place the blaster right on top of the IR_reciever on the sat box, because the blaster only has a very short range. A few mm off-place could be the difference between failure and sucess. So if you have problems in getting the sat box to react on the test program, then try to re-align the blaster/Edit When you have this working, you can close the config program. 2. Next you should enable the hauppauge blaster plugin in MP. 3. Then you have to go into the TV-channel setup and here you define which channels that need to use the blaster and which number it should use. Se my post here: [url]https://forum.team-mediaportal.com/showthread.php?t=9925[/url] Hope this helps Steen [/QUOTE]

Verification